Get it lined up and slide it down over the case and fasten at that time. If the walls are 90 degrees, you can fasten the frame to the cab, but if not, you will need to slide your case in and then raise the frame higher than the case. Slide your frame in to make sure it fits. Cut it off about 1/8" larger than the opening and hold the frame up against the other side wall at an angle like before, transfer your scribe mark allowing the 1/8", and trim this side, beveling the cut like the other side. Once you feel good about the fit, take your measurements and transfer them to the other stile. Hold the face frame up against one wall at an angle to scribe one side of the face frame (bevel the cut so you will not have as much friction on the wall). Then take a level to see if your wall is plum, and also to see if any bows are in the wall that you may need to allow for. We usually start by measuring the depth of the cab and draw a plumb line on the wall. In this case you need to leave the face frame off the cabinet and fasten the frame to cab on site. First, is the back corner a true 90? Sometimes your walls are not a true 90 and narrower at the front. There are a couple things you need to know. ![]() Place the template over the cabinet and trace around it to cut. Hold the template in place and tighten the wing nuts when the template fits perfectly. Use some small bolts and wing nuts to connect the corners. Cut slots in the end of the "rails" and drill a hole in the end of the stiles. I'd take some 1/4" plywood cut into strips and make a template. (Cabinet and Millwork Installation Forum) If I build the cabinet exactly and allow no scribe material, then I can't scribe it to the wall and a gap will be seen due to the uneven walls. The problem is, the cabinet is currently too large because of the scribe material. I've allowed 1/2" of scribe material on each side of the face frame. It will fit between two walls so the face frames will have to be scribed on both sides. ![]() I have a single cabinet that's 3 feet wide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |